Cadillac 2004 SRX - Manual (Page 362)

To remove the headlamp assembly from the vehicle and
access the bulbs, follow these steps:
1. Open the hood. See Hood Release on page 5-11
for more information.
2. Use a tool to remove all of the fasteners along the
top surface of the front fascia.
3. Use a tool to remove the one screw and one
retainer on top of the headlamp assembly.
4. Gently pull the front fascia away from the headlamp
assembly and remove the screw attached to the
bracket located at the lower inboard side of
the headlamp assembly.
5. Pull the headlamp assembly straight out to
disengage the snap in the retainer at the lower
outboard back surface of the assembly and then
turn the lamp so that the inboard corner clears the
front fascia and pull the lamp out
6. Remove the electrical harness connector from the
back side of the headlamp assembly access cap.
To replace the headlamp high and/or low beam bulb(s),
do the following:
1. Remove the three Torx ® screws on the back of the
access cap.
2. You can now access the low and high beam bulbs.
Turn the low beam (upper) bulb socket one-eighth
turn counterclockwise to remove it from the
assembly. Turn the high beam (lower) bulb socket
one-eighth turn clockwise to remove it from the
assembly.
3. Replace the bulb. See Replacement Bulbs on
page 5-55 for the proper bulb number.
4. Reinstall the three Torx ® screws while making sure
the access cap seal gasket is located in the access
cap seal channel.
5. Replace the lower outboard plastic snap-in retainer
in the fender bracket, if needed.
6. Reconnect the electrical harness at the back side of
the headlamp assembly.
7. Push the headlamp assembly straight into the
vehicle engaging the headlamp pin into the
snap-in retainer and adjusting the lamp inboard side
to clear past the front fascia.
5-52