Carl Goldberg GBGA1024 - Manual (Page 5)

5
2.
*
Remove the covering on both the ailerons &
the flaps, where the control horn slots are
located.
*
Using CA glue, attach the control horns to the
ailerons and flaps.
3.
*
Find the small aileron pushrod wire, and place
a “z” in one end.
1.
*
Collect the following parts:
(1) Wing
(4) Control Horns
(4) EZ connectors with screws and nylon nuts.
(4) Short Pushrod Wires
Flap & Aileron Pushrods
4.
*
Connect the EZ pushrod connector to the
Control horn.
*
Put the “Z” bend into the outer hole of the
servo arm.
*
Slide the pushrod wire through the connector
on the control horn and mount the arm onto
the servo.
*
Tighten the set screw onto the pushrod.
5.
*
Repeat these steps for the other aileron and
flap pushrods.
Snap Nut
Set Screw
Stabilizer
1.
*
Collect the following parts:
(1) Fuselage
(1) Stabilizer & Elevator
(1) wing
(1) 4-40 x 3/4” Socket Head Bolt
(1) #4 Washer
2.
*
Locate the hole in the center of the wing for
the wing bolt. Remove the covering over the
hole.
*
Using the 4-40 x 3/4” socket head screw and
the #4 Washer, bolt the wing to the fuselage.
3.
*
Find the center of the stabilizer, by measuring
the length of the trailing edge where the ele-
vator hinge line is located.
*
Stand the stabilizer up on its edge and using a
right triangle draw a center line up from the
trailing edge to the leading edge.
*
Find the center of the fuselage in front of
where the stabilizer sits.
*
Place the stabilizer on the fuselage using the
marks you just made.