Carl Goldberg GBGA1024 - Manual (Page 6)

6
“X” “X”
4.
*
Measure from the end of the wing to the tip of
the stab. This measurement should be the
same for both sides.
*
Mark the stabilizer where it rest on the fuse-
lage
*
Remove the covering where the stab will be
glued to the fuselage.
*
Look down the length of the fuselage and
check that the stabilizer is parallel to the wing.
If it is not then shim the low side till they are
parallel.
*
When satisfied then glue the stabilizer in place
using 5 minuet epoxy. Make sure the stabiliz-
er remains both perpendicular and parallel to
the wing and fuselage while the epoxy dries.
Elevator Control Horn
1.
*
Collect the following parts:
(1) Fuselage With Stabilizer
(2) Elevator
(1) EZ connector complete
(1) Nylon Control Horn
(1) Long Pushrod Wire
2.
*
Locate the slot in one side of the elevators
near the center.
*
Remove the covering over the slot.
*
Glue the Nylon control horn into the slot mak-
ing sure that the elevator is placed on the
work bench as shown in the previous picture.
3.
*
Take the long wire pushrod and insert the end
into the pushrod tubing inside the fuselage
next to the servo tray.
*
Attach the EZ connector to the control horn
with the adjusting screw facing out.
*
Push the elevator pushrod through the EZ
connector and snug the set screw to hold the
pushrod in place.
Bottom of Elevator
Fin & Rudder Installation
1.
*
Collect the following parts:
(1) Fuselage With Stabilizer
(1) Fin & Rudder
(1) EZ connector complete
(1) Nylon Control Horn
(1) Long Pushrod Wire
2.
*
Insert the fin into the fuselage slot.
*
Mark where the fuselage meets the fin.
*
Remove the fin from the fuselage.
*
Carefully cut the covering off the fin where the
fin will be glued to the fuselage.
*
Glue the fin to the fuselage making sure to
keep the fin perpendicular to the stabilizer.