Assembly, Warning, Unpacking – Champion Power Equipment 91050 User Manual

Page 12: 1) install the shredder chute, 2) install the handle, 3) install the chipper chute

Advertising
background image

9

REV 91050-20140620

ENGLISH

91050

ASSEMBLy

Your chipper-shredder requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
chipper-shredder, call our help line at 1-877-338-0999.
Please have your serial number and model number available.

Unpacking

1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of

shipping crate.

3. Locate all hardware before beginning assembly.

1) Install the Shredder Chute

1. Align the holes in the upper shredder chute (#53)

with the holes in the lower shredder chute (#52). (A)

2. Insert M8x16 bolt (#43) into the hole of the chutes,

from top to bottom direction. (B)

3. Secure bolt with washer (#21) and lock nut (#22).
4. Tighten till secure. Do not over tighten.
5. Repeat step 2-4 for all holes in the chutes.

2) Install the Handle

1. Insert handle ends (#56) into the receptacles on the

lower shredder chute (#52). (A)

2. Secure handle end by threading bolt M8x35 (#11),

through lock washer (#30) and washer (#14), and
then through the handle. (B)

3. Tighten till secure. Do not over tighten.
4. Repeat step 2-3 until both handle ends are secure.

3) Install the Chipper Chute

1. Line up the upper chipper chute (#18) with the

rubber blocker (#20), and with the lower chipper
chute (#23). (A)

2. Once aligned, insert bolt M6x20 (#19) through the

hole in the upper and lower chipper chute. Insert
bolt from top to bottom direction. (B)

3. Secure bolt with washer (#21) and lock nut (#22).

(B)

4. Tighten till secure. Do not over tighten.
5. Repeat step 2-4 for all holes in the chutes.

Make sure chutes are fully secured with all the holes
aligned and filled with bolts. If parts are damaged or
missing do not use the unit until replacement parts
have been obtained.

NOTE

Make sure the rubber blocker (#19) is secure
between the top and bottom chutes. Do not operate
unit if blocker is damaged or missing.

WARNING

53

21

22

43

52

B

A

56

11

30

14

B

A

18

19

20

23

21

22

B

A

Advertising