Champion Power Equipment 91050 - Manual (Page 18)

15
REV 91050-20140620
ENGLISH 91050
If the impeller or blades strike a foreign object,
stop engine immediately. Do not continue use until
chutes and unit have been thoroughly inspected.
Do not attempt to unclog any jam or chute while
engine is on or spark plug wire is connected.
DANGER
This machine has rotating blades and parts capable
of amputating body parts. This machine can also
throw objects at high velocity, long distances.
Exercise extreme caution when operating the
chipper-shredder. NEVER insert body parts or
foreign object into any chute at any time. Never
look directly into any chute, as projectiles can
backfire.
DANGER
OPERATION
ALWAYS use the chipper-shredder for its intended
uses only. The chipper-shredder should only be
used to chip branches 3 in. (7.6 cm) or less in
diameter, or to shred leaves and brush. DO NOT
chip anything that is larger than 3 in. (7.6 cm) in
diameter.
NEVER modify, alter or change the chipper-
shredder in anyway. Modifications will void the
warranty and may result in damage or injury.
DO NOT modify or change the engine and operating
speeds. These changes can cause safety issues.
ONLY operate the chipper-shredder in daylight.
NEVER operate, or let anyone else operate, the
chipper-shredder while under the influence of
alcohol, drugs, or medication.
NEVER leave the chipper-shredder unattended
while the engine is running.
Avoid contact with the muffler, as it can cause
serious burns.
WARNING
Always be aware of who and what is in the
immediate and surrounding areas of the chipper-
shredder. Operators should always work in the SAFE
ZONE only.
NOTE
Chipper-Shredder Operation
1. ALWAYS wear ear and eye protection, protective shoes
and clothing, and proper safety gear.
2. Block tires and put both support mounts in the
DOWN position to prevent unintended movement of
the chipper-shredder during operation.
3. Tie back long hair. Do not wear loose fitting clothing
or jewelry.
4. Make sure surrounding, immediate and safe zones
are clear of distractions and debris.
5. Do not attempt to chip or shred material that is larger
than specified. This may damage the unit or cause
injury.
6. Make sure the materials that are going to be chipped
or shredded are free of any rocks, trash, metals and
other foreign objects.
7. Make sure wood to be chipped has been “trimmed”
down and do not have any excessive branches.
8. Make sure wood to be chipped or leaves/brush to be
shredded are not “wet” as this may clog the chutes.
9. Keep all chutes, deflectors and guards assembled
and in place at all times.
Chipper-Shredder Operation Cont’d.