Champion Power Equipment 90720 - Manual (Page 12)

9
REV 90720-20131010
ENGLISH 90720
ASSEMBLy
A screwdriver can be inserted into the cylinder
rod’s bolt hole to rotate to proper position prior to
installing the ram bracket.
NOTE
The cylinder should extend in the opposite direction
of the beam as shown.
NOTE
6) Install the Ram Bracket to the Cylinder
1. Slide the ram bracket (#2) over the rod on the
cylinder being sure to align the bolt holes.
2. Insert the M10x60 bolt (#3) through the ram
bracket and cylinder rod.
3. Secure the bolt with M10 lock nut (#1). Do not over
tighten.
7) Install the Handle
1. Slide the handle (#31) into the tube bracket on the
end of the beam.
2. Secure with clip ring (#32).
8) Install the Hoses
1. Use 2 hose clamps (#9) to install the clear suction
hose (#19) from the pump inlet (A) to of the back of
the beam/tank (B) as shown.
2. Use 2 hose clamps (#9) to install the oil return hose
(#10) from the control valve outlet (D) to the back
of the beam/tank as shown (C).
3. Connect one end of the high-pressure hose
(#40) to the control valve outlet (E) and tighten
approximately ¼ turn past finger tight.
4. Rotate/adjust the high-pressure hose (#40) to run
to the inside of the fuel cap on the engine.
5. Thread the other end of the high-pressure
hose (#40) to the pump outlet (F) and tighten
approximately ¼ turn past finger tight.
A
A
B
B
C
C
D
D
F
F
E
E
5) Install the Cylinder to the Beam
1. Slide the cylinder pegs into the cylinder mounting
slots on the top of the beam.
2. Secure the cylinder retention plates (#20) with
M10x20 bolts (#23) M10 lock washers (#22) and
M10 washers (#21).