Champion Power Equipment 90720 - Manual (Page 18)

15
REV 90720-20131010
ENGLISH 90720
MAINTENANCE AND STORAGE
The owner/operator is responsible for all periodic
maintenance.
Complete all scheduled maintenance in a timely manner.
Correct any issue before operating the log splitter.
For service or parts assistance, contact our help line
at
1-877-338-0999.
NOTE
Never operate a damaged or defective log splitter.
WARNING
Improper maintenance will void your warranty.
WARNING
Engine Maintenance
To prevent accidental starting, remove and ground spark
plug wire before performing any service.
Oil
Change oil when the engine is warm. Refer to the oil
specifi cation to select the proper grade of oil for your
operating environment.
1. Remove the oil drain plug with a 12 mm socket and
extension.
2. Allow the oil to drain completely.
3. Replace the drain plug.
4. Remove oil fi ll cap/dipstick to add oil.
5. Add up to 0.42 qt. (0.4 L) of oil and replace oil fi ll
cap/dipstick. DO NOT OVERFILL.
6. Dispose of used oil at an approved waste
management facility.
Spark Plugs
1. Remove the spark plug cable from the spark plug.
2. Inspect the electrode on the plug. It must be clean
and not worn to produce the spark required for
ignition.
3. Make certain the spark plug gap is 0.7 - 0.8 mm
(0.028 - 0.031 in.).
Log Splitter Maintenance
Make certain that the log splitter is kept clean and stored
properly. Only operate the unit on a fl at, level surface in
a clean, dry operating environment. DO NOT expose the
unit to extreme conditions, excessive dust, dirt, moisture
or corrosive vapours.
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed.
Clean spark arrester every 100 hours (if equipped).
Check and tighten all bolts and nuts before operating the
log splitter.
Air Filter
1. Unscrew wing nut to remove the air fi lter cover.
2. Unscrew wing nut to remove the air fi lter.
3. Separate the foam element and the paper element.
4. Tap the paper fi lter element to remove dirt and
debris. Use compressed air (25 PSI) to clear debris.
5. For the foam element: Wash in liquid detergent and
water. Squeeze thoroughly dry in a clean cloth.
6. Saturate in clean engine oil.
7. Squeeze in a clean, absorbent cloth to remove all
excess oil.
8. Reassemble the two elements and reattach. Tighten
wing nut.
9. Reattach the air fi lter cover and snap in place.
0.7 - 0.8 mm
0.028 - 0.031 in.
4. Refer to the spark plug recommendation chart when
replacing the plug.
5. Carefully thread the plug into the engine.
6. Use the spark plug tool to fi rmly install the plug.
7. Attach the spark plug wire to the plug.