Safety rules, Maintenance and storage, Operation – Champion Power Equipment 90720 User Manual

Page 9

Advertising
background image

REV 90720-20131010

6

90720

ENGLISH

SAFETy RULES

Maintenance and Storage

1. Always shut off the power source while repairing or

adjusting the splitter except as recommended by the
manufacturer.

2. Clean debris and chaff from the engine cylinder,

cylinder head fins, recoil starter cover, and muffler
areas. If the engine is equipped with a spark
arrestor muffler, clean and inspect it regularly
(follow manufacturer’s service instructions).
Replace, if damaged.

3. Never store the unit indoors with fuel in the tank.

Fumes might reach an open flame spark. Allow the
engine to cool before storing in any enclosure.

4. Clear debris from moveable parts, but only when the

power source is shut off.

5. Check to be sure all nuts and bolts are tight to

assure the equipment is in safe working condition.

Operation

1. Before starting this log splitter, review all safety

rules. Failure to follow these rules may result in
serious injury to the operator or bystanders.

2. Be sure to confirm all hose connections and hose

clamps are tight before each use. It is possible for
connections to vibrate loose over time.

3. Never leave the machine unattended with the power

source operating.

4. Never operate the machine when under the

influence of alcohol, drugs or medication.

5. The machine owner should instruct all operators in

safe log splitter operation.

6. Always operate the log splitter with all safety

equipment in place and all controls properly
adjusted for safe operation.

7. Always operate the log splitter at manufacturer’s

recommended speed.

8. Always keep hands and feet clear of moving parts.
9. When loading a ram-type log splitter, place your

hands on the sides of the log, not the ends. Never
place your hands or any part of your body between a
log and any part of the log splitter.

10. On ram-type log splitters, never attempt to split

more than one (1) log at a time unless the ram has
been fully extended and a second log is needed to
complete the separation of the first log.

11. On ram-type log splitters on which the logs are not

cut square, the longest portion of the log should be
rotated down and the most square end placed against
the ram.

12. Use only your hand to operate the log splitter

controls.

13. Do not refuel the engine until it has cooled for several

minutes.

Advertising