Vehicle messages, Drive systems -37, Vehicle messages -23 – CHEVROLET 2011 Equinox User Manual

Page 139

Advertising
background image

Black plate (23,1)

Chevrolet Equinox Owner Manual - 2011

Instruments and Controls

5-23

Tire Pressure

The display will show a vehicle with
the approximate pressures of all
four tires. Tire pressure is displayed
in either kilopascal (kPa) or in
pounds per square inch (psi).

See Tire Pressure Monitor System
on page 10‑50
and Tire Pressure
Monitor Operation on page 10‑52
for
more information.

Remaining Oil Life

This display shows an estimate of
the oil's remaining useful life.
If REMAINING OIL LIFE 99% is
displayed, that means 99% of the
current oil life remains.

When the remaining oil life is low,
the CHANGE ENGINE OIL SOON
message will appear on the display.
See Engine Oil Messages on
page 5‑26
.
The oil should be
changed as soon as possible. See
Engine Oil on page 10‑10. In
addition to the engine oil life system
monitoring the oil life, additional
maintenance is recommended in the

Maintenance Schedule in this
manual. See Scheduled
Maintenance on page 11‑2
for more
information.

Remember, the Oil Life display must
be reset after each oil change. It will
not reset itself. Also, be careful not
to reset the Oil Life display
accidentally at any time other than
when the oil has just been changed.
It cannot be reset accurately until
the next oil change. To reset the
engine oil life system, press SET/
CLR while the Oil Life display is
active. The display will ask for
confirmation of a reset. Press

w

or

x

to select Yes or No. Then press

SET/CLR to confirm the selection.
See Engine Oil Life System on
page 10‑13
.

Blank Display

This display shows no information.

Compass

The vehicle may have a compass in
the Driver Information Center (DIC).
See Compass on page 5‑4.

Vehicle Messages

Messages are displayed on the DIC
to notify the driver that the status of
the vehicle has changed and that
some action may be needed by the
driver to correct the condition.
Multiple messages may appear one
after another.

Some messages may not require
immediate action, but you can press
SET/CLR to acknowledge that you
received the messages and to clear
them from the display. Some
messages cannot be cleared from
the DIC display because they are
more urgent. These messages
require action before they can be
cleared. You should take any
messages that appear on the
display seriously and remember that
clearing the messages will only
make the messages disappear, not
correct the problem. You will find the
possible messages that can be
displayed and some information
about them grouped by subject in
the following information.

Advertising