CHEVROLET 2010 Express - Manual (Page 111)

The horn may chirp when Q is pressed again within
five seconds. See DIC Vehicle Customization on
page 4-52 for additional information.
K (Unlock): Press to unlock the driver door. If K is
pressed again within five seconds, all remaining
doors unlock.
The interior lamps come on and stay on for 20 seconds
or until the ignition is turned on. If enabled through
the DIC, the parking lamps flash twice to indicate
unlocking has occurred. See DIC Vehicle Customization
on page 4-52 for additional information.
j (Cargo Door): Press to unlock only the cargo
doors.
/ (Remote Vehicle Start): For vehicles with this
feature, press Q and then press and hold / within
five seconds to start the engine from outside the vehicle
using the RKE transmitter. See Remote Vehicle Start
on page 3-7 for additional information.
L (Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The turn signal lamps flash and
the horn sounds three times.
Press and hold L for more than two seconds to
activate the panic alarm. The turn signal lamps flash
and the horn sounds repeatedly for 30 seconds.
The alarm turns off when the ignition is moved to
ON/RUN or
L is pressed again. The ignition must be
in LOCK/OFF for the panic alarm to work.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen transmitters
no longer work once the new transmitter is programmed.
Each vehicle can have up to four transmitters
programmed to it. See “Relearn Remote Key” under DIC
Operation and Displays on page 4-37 for instructions on
how to match RKE transmitters to your vehicle.
3-5