Finding a station – CHEVROLET 2010 Express User Manual

Page 214

Advertising
background image

H

(Clock) (AM-FM Radio and Radio with CD (Base)):

The radio has a clock button for setting the time.
With this type of radio, the clock can be set with either
the radio turned on or off. See Setting the Clock on
page 4-60
for more information.

Speed Compensated Volume (SCV): Radios with
Speed Compensated Volume (SCV) automatically
adjusts the radio volume to compensate for road and
wind noise as you speed up or slow down while driving.
That way, the volume level should sound about the
same as you drive.

To activate SCV:

1. Set the radio volume to the desired level.

2. Press the MENU button to display the radio

setup menu.

3. Press the pushbutton under the AUTO VOLUM

label on the radio display.

4. Press the pushbutton under the desired Speed

Compensated Volume setting (OFF, Low, Med,
or High) to select the level of radio volume
compensation. The display times out after
approximately 10 seconds. Each higher setting
allows for more radio volume compensation at faster
vehicle speeds.

Finding a Station

BAND: Press to switch between FM1 and FM2 and AM.
The selection displays.

f

(Tune): Turn clockwise or counterclockwise to

increase or decrease the station frequency.

©

SEEK

¨

: Press the arrows to go to the previous or

to the next station and stay there.

To scan stations, press and hold either arrow for
two seconds until a beep sounds. The radio goes
to a station, plays for a few seconds, then goes to
the next station. For AM-FM Radio and Radio with
CD (Base), the station frequency flashes while the radio
is in the scan mode. Press either arrow again to stop
scanning.

The radio seeks and scans stations only with a strong
signal that are in the selected band.

For AM-FM Radio and Radio with CD (Base), scan
presets within the current selected band by pressing and
holding either SEEK arrow for four seconds until a double
beep sounds. The radio goes to a stored preset, plays for
a few seconds if a strong signal is present, then goes to
the next stored preset. The station frequency flashes
while the radio is in the scan mode.

4-64

Advertising