CHEVROLET 2010 Express User Manual
Page 318
8. Now connect the black negative (
−
) cable to the
negative (
−
) terminal of the good battery. Use a
remote negative (
−
) terminal if the vehicle has one.
Do not let the other end touch anything until the
next step. The other end of the negative (
−
) cable
does not go to the dead battery. It goes to a heavy,
unpainted metal engine part or to a remote
negative (
−
) terminal on the vehicle with the dead
battery.
9. Connect the other end of the negative (
−
) cable to
the negative (
−
) terminal location on the vehicle
with the dead battery. Your vehicle has a remote
negative (
−
) terminal for this purpose. It is
marked GND.
10. Now start the vehicle with the good battery and run
the engine for a while.
11. Try to start the vehicle that had the dead battery.
If it will not start after a few tries, it probably needs
service.
Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by the vehicle warranty. Always
connect and remove the jumper cables in the correct
order, making sure that the cables do not touch
each other or other metal.
A. Heavy, Unpainted Metal Engine Part or Remote
Negative (
−
) Terminal
B. Good Battery or Remote Positive (+) and Remote
Negative (
−
) Terminals
C. Dead Battery or Remote Positive (+) Terminal
Jumper Cable Removal
6-48