CHEVROLET 2010 Equinox - Manual (Page 195)

Infotainment System 6-53
3. Say the entire number without
pausing.
. If the system recognizes
the number, it responds
with “OK, Dialing” and dials
the number.
. If the system does not
recognize the number, it
confirms the numbers
followed by a tone. If the
number is correct, say
“Yes”. The system responds
“OK, Dialing” and dials the
number. If the number is
not correct, say “No”. The
system will ask for the
number again.
Using the Digit Dial Command
1. Press
b
/
g
.
. For vehicles without a
navigation system, the
system responds “Ready”,
followed by a tone.
. For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
“Hands Free”. The system
responds “Ready”, followed
by a tone.
2. Say “Digit Dial”. The system
responds “Digit dial using
<phone name>, please say the
first digit to dial”, followed by
a tone.
3. Say the digits to be dialed one at
a time. The system repeats back
the digit it heard followed by
a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”. The
system responds “OK, Dialing”
and dials the number.
. If an unwanted number is
recognized by the system,
say “Clear” at any time to
clear the last number.
. To hear all of the numbers
recognized by the system,
say “Verify” at any time.