License plate lamp, Plate lamp -36, 36 vehicle care – CHEVROLET 2010 Equinox User Manual
Page 314
9-36
Vehicle Care
5. Disconnect the lamp wiring
harness.
6. Turn the bulb socket
counterclockwise and pull it out.
7. Pull the bulb straight out of the
socket.
8. Install the new bulb.
9. Push the bulb socket in and turn
it clockwise.
10. Reverse steps 2 through 5 to
reinstall lamp assembly.
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate partway. See
Liftgate (Manual) on page 1‑8
or Liftgate (Power) on
page 1‑9 for more information.
Passenger side shown, driver side
similar
2. Push the left end of the lamp
assembly towards the right.
3. Pull the lamp assembly down to
remove from liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A)
counterclockwise to remove from
lamp assembly (C).
5. Pull the bulb (B) straight out of
the bulb socket.