Clarity Cordless Telephone - Manual (Page 12)

TABLE/DESK TOP INSTALLATION
CAUTION:
Disconnect the telephone line cord before
connecting or disconnecting the battery backup in the
wall mount bracket.
1. Plug one end of the supplied modular telephone
line cord into the jack marked TEL located on the
back of the telephone base as shown in the
diagram.
2. Plug the modular telephone line cord’s other end
into a modular phone jack.
3. Insert the supplied AC Adapter’s plug into the
jack marked 9V DC 400mA located on the back
of the telephone base.
4. Plug the adapter into a standard 120V AC power
(electrical) outlet.
5. Align the mounting bracket on the back of the
base so that the black rubber feet are towards the
bottom of the phone. Insert the bracket’s tabs into
the slots and secure the bracket by sliding it
upward.
6. Lift the base’s antenna to a vertical position.
7. Set the TONE/PULSE switch located on the back
of the base to correct dialing mode. Please check
with your local Phone Company if uncertain of the
12