Chicago Electric 97677 - Manual (Page 10)

Page 10 SKU 97677 For technical questions, please call 1-800-444-3353.
Wet Vacuuming:
Unlock the Right Latch (34) and Left 1.
Latch (59). Then remove the Upper
Cover (9).
(See Figure A, and Assy. Diagram.)
Snap the Foam Filter (85) over
2.
the Filter Cage (84). nOTE: The
Foam Filter must be flush with the
underside of the Upper Cover (9).
(See Figure A.)
Replace the Upper Cover (9), and
3.
lock the Right Latch (34) and Left
Latch (59).
(See Figure A, and Assy. Diagram.)
Attach the Suction Hose (50) to the
4.
Intake Port (49). (See Figure A.)
Extend the Telescopic Suction Tube 5.
(82), and attach it to the end of the
Suction Hose (50). (See Figure A.)
Attach either the accessory Wet & 6.
Dry Brush (83), Crevice Nozzle (86),
or Furniture Brush (87) to the end of
the Telescopic Suction Tube (82).
(See Figure A.)
Plug the Power Cord (11) into the
7.
nearest 120 volt, grounded, electrical
outlet.
Turn the Switch Knob (80) to its
8.
“On” position to start the Wet/Dry
Vacuum. (See Figure A.)
Adjust the air flow rate of the Vacuum 9.
by sliding the Air Flow Adjusting Knob
(67) to the left or right.
(See Figure A.)
Guide the accessory Wet & Dry
10.
Brush (83), Crevice Nozzle (86),
Furniture Brush (87) with slight
pressure, slowly and evenly, over the
dirty water. (See Figure A.)
IMPORTAnT: 11. The Wet/Dry Vacuum
features Safety Float (63) which will
automatically stops the vacuuming
when the Tank (35) is full (as
indicated when the Motor speed
increases). If this happens, turn off
the Switch Knob (80) and unplug the
unit from its electrical outlet. Then
position the Vacuum near a drain,
and drain the dirty water using the
Drain Hose (29). (See Figure A.)
When finished vacuuming, turn 12.
the Switch Knob (80) to its “OFF”
position. Then unplug the Wet/Dry
Vacuum from its electrical outlet.
(See Figure A.)
Position the Vacuum near a drain,
13.
and drain the dirty water using the
Drain Hose (29). (See Figure A.)
Unlock the Right Latch (34) and Left 14.
Latch (59). Then remove the Upper
Cover (9).
(See Figure A, and Assy. Diagram.)
Remove the Foam Filter (85) from
15.
the Filter Cage (84). If necessary,
the Foam Filter may be cleaned with
running water. Then clean and dry
the Tank (35) inside and out.
(See Figure A.)
Replace the Upper Cover (9), and
16.
lock the Right Latch (34) and Left
Latch (59).
(See Figure A, and Assy. Diagram.)
Keep the accessories in the
17.
Vacuum’s built-in storage
receptacles, and store the unit in a
clean, dry, safe location out of reach
of children and other unauthorized
people.
REV 10c