Using cancel/drain, To clear the indicators, To cancel a cycle – Whirlpool 960 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING THE CONTROLS
CYCLE
HEAVY
Double wash for cleaning
heavily soiled loads.
• Select High Temp Wash
to heat water in the main
wash (marked t).
•The water heats to 140°F (60°C) in
the final rinse (marked unless you
select Low Energy Rinse.
A “•" shows what each cycle includes
WASH RINSE
MAIN
WASH RINSE
FINAL
RINSE DRY
•tt
CYCLE
TIME
(Minutes)
76*
POTS-N-PANS
Double wash for maximum
cleaning of cooked-on or
baked-on foods.
• The water heats to 140°F
(60°C) in both washes
(marked +).
The water heats to 140°F (60°C) in
the final rinse (marked tt) unless
you select Low Energy Rinse.
•t
•t
•tt
76*
Cycle time includes dry time and may be longer depending on the temperature of water entering the dishwasher.
The cooler the water, the longer the cycle time. If the water is already hot enough, the cycle times will be as shown.
Using Cancel/Drain
Press Cancel/Drain to cancel a cycle or to
clear the indicators.
To clear the indicators:
Press Cancel/Drain before starting
the dishwasher to clear all cycle and option
selections.
To cancel a cycle:
• Press Cancel/Drain whiie the dishwasher
is running to start a
2
-minute
drain. It will take a few seconds for the
drain to start. If desired, select a new
cycle. (See “Changing a cycie or an
option setting" on page 15.)
• You can press Cancei/Drain again to stop
the drain immediately. Remember to drain
the dishwasher again before starting a
new cycle.
NOTE:
A small amount of water remaining
in the dishwasher is normai.
14