Whirlpool EVZOON - Manual (Page 4)

the weight of a fully loaded freezer.
2 Pick a safe place, indoors, away from in­
flammables such as gasoline.
3, Allow
'/2
Inch (1,25 cm] on each side of the freezer
for ease of installation.
4. If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
Level freezer...
so the door will stay
open at any position.
Levelling
Leg
Raise
Lower
Start adjustment with the door hinge
side.
1. Slide freezer into place,
2. Remove base grille, (see page 6).
3. Adjust front legs to level the freezer.
- To raise front, turn legs in
direction shown.
- To lower front, turn legs in
direction shown,
4. Check with level.
5. After freezer is fully loaded, recheck
with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining giue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2, Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1.
DO NOT USi rubbing alcohoi or fiammabie or
toxic soivents, such as acetone, gasoiine, car­
bon tetrachioride, etc. These can damage the
materiai.
NOTE: DO NOT REMOVE the Tech Sheet fas­
tened under the freezer at the front.
Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer
Power Plug 3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving oniy
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer