Removing the base grille, The signal light, Energy saving tips – Whirlpool EVZOON User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing the base grille...
1. Open the door.
2. Pull grille outwards as shown,
3. Do not remove Tech sheetfastened behind grille.
Metal Clips
Support Tabs
To replace:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place,
3. Close the door.
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal light is not glowing,
immediately check;
• for power interruption,
• for an unplugged power cord,
• for a burned out signal light.
To replace:
1. Unplug the power cord.
2. Remove the base grille, (see page 6].
3. Unplug burned out light and replace
with one of the same wattage and
size. Signal light can be ordered from
your WHIRLPOOL dealer. Part No.
530584.
4. Replace the base grille and plug in
the power cord.
Energy saving tips...
You can help your freezer use less electricity.
• Check door gasket and level freezer to assure a
good door seal.
• Clean the condenser coils regularly.
• Keep door openings to a minimum. Remove several
items at one time. Keep contents organized to elimi
nate searching.
• Fill to capacity. Follow recommended procedures
for freezing foods. See pages 8 and 9.
' Set Temperature Control to provide temperatures
around 0°F (-17.8 °C). There is no need to store
foods below 0°F.
' Keep door locked to ensure door closure.
' Do not let frost build up to more than V
a
inch (6 mm)
thick. Efficiency is reduced.
Keep Power Saving Control on CFF when humidity is
low.