Whirlpool EVZOON - Manual (Page 5)

Using your freezer
The Power Saving Control...
operates electric heaters. These heaters help pre­
vent moisture from forming on the outside of the
freezer when humidity is high.
1. Use the OFF setting when humidity is low.
2. Use the ON setting only if moisture forms on the
outside of the freezer.
Setting the temperature control...
To start, turn control to the middle of the dial. This
setting is designed to maintain the temperature at
or near 0°F (-17.8 °C) under normal operating
conditions.
Adjusting the temperature control... |
1. Turn control to higher number for colder temper­
atures.
2. Turn to lower number for less cold temperatures.
Cooling freezer first...
1. Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2. Let it cool overnight before adding large amount
of unfrozen food.
Note: When freezer is first started, the compressor
will run constantly until the cabinet is cooled. It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door is opened.
After the cabinet is cooled, the compressor will
turn ON and OFF as needed to keep the freezer at
the proper temperature.
Changing the light hulh...
WARNING: To avoid possible shocks, firsf unplug
freezer or turn off electricity ieading
to freezer at the main power supply.
Light Shield
Removing the bottom basket...
To remove:
1, Lift up on basket,
2. Pull out.
To replace:
1. Insert into rear slides,
2. Lower into place.
3. Push basket into place.
Lift up
Then out
1. Remove light shield by pulling away
from the side wall.
2. Replace bulb with a 40-watt ap­
pliance bulb.
3. Replace the light shield. Insert the
shield tabs in the wall slots, then press
the shield to snap into place,
4. Plug in the power cord.
The key eject lock...
can help reduce the hazard of child
entrapment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com­
plete
model and serial number of your freezer
when requesting a replacement key.