Whirlpool EV170NX - Manual (Page 5)

I N S T A L L I N G Y O U R F R E E Z E R
Installing Your Freezer
In This Section
Page
Page
Installing the handle....................................._____ 5 Choosing the proper location------------ ....... ........6
Cleaning your freezer..................................._____ 5 Completing the installation.................. ............... 6
Locating the proper electrical supply.... ...........5
Proper installation of any appliance is very important. This section will tell you everything you need to
know to install your freezer properly.
Installing the handle
1. Remove screws from front of freezer door and
discard.
2. Locate handle assembly krt among packing
materials.
3. Attach top of handle to top hole in door with
shorter of 2 screws provided.
4. Attach bottom of handle to lower hole in door
with longer of 2 screws.
5. Snap trim piece into place.
Cleaning your freezer
Clean your freezer thoroughly before using it.
1. Use a sponge, cloth or paper towel and mild
detergent in warm water to clean outside and
inside of freezer, door liner and gasket.
2. Rinse and dry thoroughly.
Locating the proper electrical supply
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere
fused and properly grounded electrical supply is
required. It is recommended that a separate
circuit serving only this appliance be provided.
Use a receptacle which cannot be turned off with
a swKch or pull chain. Do not use an extension
cord.
Attach retaining clip, from literature package
inside the freezer, over power cord plug. See
Electrical Requirements and Grounding Instruc­
tions Sheet in literature package for complete
details.
3-prong grounding
type wall receptacle
Retaining clip
Freezes
power plug
3-prong
grounding
plug