Whirlpool AD0402XS0 - Manual (Page 8)

. To remove outer cabinet:
a Disconnect power cord.
Take off the plastic grille. Remove the two
screws at the bottom. Drop grille down and
take out.
TOP FLANGE
SCREWS
SOCKET HEAD
SCREWS
(side of cabinet)
c. Remove the socket head screws on each side
and top flange screws (see illustrations). On 30,
40 and 48 pt. models, also remove rear grille.
Pull out at bottom and drop grille down,
d Lift cabinet from unit.
2. Coils should be inspected annually. If needed,
brush clean with warm water and mild de­
tergent. Rinse and dry. Be sure power supply
cord is disconnected.
A WARNING: Be careful when cleaning
the condenser colls. Fins are sharp
and could cause personal Injury.
3. The compressor is sealed and needs no oiling
COILS
4. The fan motor is prelubricated and does not
require further oiiing under normai operating
conditions. However, if the dehumidifier is oper­
ated under severe environmental conditions
(dust, dirt, high temperatures) the fan motor
should be oiled annually through the provided
oil tubes (holes). An easy to use capsule of es­
pecially recommended oil (Part Number 10943)
is available through your nearest Whirlpool
Factory Service Center, or use SAE #20 non­
detergent oil.
5. Wash plastic parts with a soft cloth, warm wafer
and mild detergent. Rinse and dry with a soft
cloth.
OIL FAN
MOTOR
(Back Oil
Hole Not
Shown)
6 .
Replace cabinet grille(s). Reconnect power
supply cord.