ClearSounds A50 - Manual (Page 16)

1
1. Press the “ SEL” button once then the LCD display will show PROGRAM to
indicate you entered the SETTING MODE.
2. Press the 4 key, then the SET TIME will show on the LCD display and the digit
for MONTH will flash (the sequence is MONTH-DAY-HOUR-MINUTE).
3. Press the or arrow button to get the desired number.
4. Press the “ SEL” button to confirm.
5. To set the DAY - Press the or arrow button to get the desired number
and press the “ SEL” button to confirm.
6. To set the HOUR - Press the or arrow button to select the correct
number (12H am/pm), followed by the “ SEL” button to confirm.
7. To set the MINUTES - Press the or arrow button to enter the
MINUTES. After the last setting (MINUTES) is completed press the “ SEL” button
to confirm.
8. A confirmation beep will sound.
Auto Amplify Modes/Volume Reset Override
You can increase the volume and adjust the receiving tone according to your own
hearing requirements.
NOTE: When the AMPLIFY mode is turned ON automatically or manually, the Amplify
Indicator light will remain lit (See page #7 for location) .
I. Auto Amplify ON
To set handset amplifier so that it will AUTOMATICALLY return to your previous volume
setting every time you use the handset without having to press the “ AMPLIFY” button.
1. Simply turn the “ AUTO AMPLIFY” switch in the battery compartment to the ON
(up) position using the tip of a pencil. When the “ AUTO AMPLIFY” switch is in
the ON position, you do not need to press the “ AMPLIFY” button on the side of
the handset. On any call, you can temporarily turn OFF and turn back ON the
AUTO AMPLIFY feature by pressing the “AMPLIFY” button.
II. Auto Amplify OFF
To set your handset in the standard mode so that it will reset to normal sound levels when
you hang up. This allows people who do not require the level of amplification offered on
the phone to use it.
1. Turn the “ AUTO AMPLIFY” switch in the battery compartment to the OFF (down)
position. The amplify feature is automatically deactivated each time you use the
phone. You will manually need to activate the function temporarily by pressing
the “ AMPLIFY” button.