Operating the self-cleaning oven, How to set oven for cleaning, To stop a clean cycle – GE JRP14 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING THE SELF-CLEANING OVEN
(continued)
How to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycle, the word “OFF’ will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1. Follow the directions in the Before a Clean Cycle
section.
2. After closing the door, press the AUTO
SELF CLEAN pad.
3. Press the INCREASE or
DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to anytime
between 2 and 4 hours, depending on
the amount of soil in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean cycle
is set. The words “ON” and “LOCK” will appear in the
display when the door automatically locks. It will not
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off. ■
4. When the LOCK light is off, open the door.
NOTE:
■ You can find out when the clean cycle
will be finished by pressing the STOP
TIME pad.
' The word “door” will be displayed, the word
“LOCK” will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
’ A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
2. When the LOCK light goes off and the oven has
cooled below the locking temperature, open the door.
20