GE JRP14 - Manual (Page 21)

w\
Vfter Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
lows the correct time of day.
1. Follow the directions in the Before a Clean Cycle
section.
2. After closing the door, press the AUTO
SELF CLEAN pad.
AUTO SELF
CLEAN
3. Press the INCREASE or DECREASE
pad to enter the Clean Time.
STOP
TIME
4. Press the STOP TIME pad. “STOP
TIME” and the earliest Stop Time you
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time of day is 6:00,
the Stop Time that appears in the display will be 9:00.
5. Press the INCREASE pad to change the
Stop Time to a later time of day if
desired. For example: If you set Stop
Time at 11:00, oven will start clean cycle
at 8:00 and end at 11:00. The door
latches automatically.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for clean cycle
is set. The words “ON” and “LOCK” will appear in
the display when the door automatically locks. It
will not be possible to open the oven door until the
temperature drops below the lock temperature and
the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
• During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the AUTO SELF CLEAN pad for 3 seconds.
• A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
{continued next page)
o
IS
ft
n
s’
(W
ft
C/5
ft
7*
Q
fT
s
s
S
CTQ
O
ft
s
21