Cisco 1751 - Manual (Page 42)

Chapter 2 Installation
Optional Installation Steps
2-14
Cisco 1751 Router Hardware Installation Guide
78-11258-04
Follow these steps to mount the router on a wall or other surface:
Step 1 Install the two screws 3.75 inches (9.52 centimeters) horizontally apart on a wall
or other vertical surface.
The screws should protrude 0.25 inches (0.64 centimeters) from the surface of the
wall.
Step 2 Hang the router on the screws with either the left side or right side mounting
brackets so that
• The LEDs are visible to the user. The LEDs indicate the router operating
status, so the LEDs should be easily visible.
• The power supply does not hang from its cable. If the power supply is not
supported, it might disconnect from the cable that connects it to the router.
Caution If you install the screws in drywall, use hollow wall anchors (1/8 inch
by 5/16 inch) to secure the screws. If the screws are not properly anchored, the
strain of the cables connected to the router rear-panel connectors could pull the
router from the wall.