Cisco 1751 - Manual (Page 37)

2-9
Cisco 1751 Router Hardware Installation Guide
78-11258-04
Chapter 2 Installation
Verifying Your Installation
Figure 2-4 Connecting the Power Supply
Verifying Your Installation
You can verify that you have correctly installed the router by checking the
following LEDs:
• PWR (front panel)—On when power is being supplied to the router.
• OK (front panel)—On when the router software is loaded and functional.
Blinking means that the router is performing a power-on self-test (POST).
• ETH ACT (front panel)—Blinking when there is network traffic on the local
Ethernet LAN.
+5, +12, -12
VDC
CONS OLE
AUX
Model Cisco 1750
10/100 E THERN ET
SEE M ANU AL B EFOR E IN STAL LATIO N
VIC
2FXO
PVDM O K
MOD O K
SLOT 1
SLOT 2 OK
FDX
SLOT 0 OK
SLOT 1 OK
100 LINK
THIS S LOT ACCE PTS ONLY VOIC E INTER FACE CARD S
SLOT 2
SLOT 0 1
IN USE
0
IN USE
SEE M ANU AL B EFOR E IN STAL LATIO N
VIC
2FXS
1
IN USE
0
IN USE
Power supply
Power socket
46566
Separate
power cord
Attached
power supply cord