GE ELECTRONIC TOUCH CONTROL PP980 - Manual (Page 13)

Cleaning the glass cooktop. ge.com
Control Lock Pad
As a convenience, you can lock the
entire cooktop at any time when it is
not in use or before cleaning.
l.ocking the cooktop will jrrevent
surface elements from being turned
on accidently.
Begin by locking the cooktop; see
the Locking the Cooktop section. Use
the same cleaning methods as those
described for the glass-ceramic toj>.
Clean your cooktop after
each spill. Use ceramic
cooktop cleaner.
Normal Daily Use Cleaning
ONLY use ceramic cooktop cleaner on
the glass cooktop. Other creams may not
be as effective.
To maintain and protect the surface of
your glass cooktop, follow these stejrs:
Before using the cooktop for
the first time, clean it with ceramic
cooktop cleaner. This helps protect
the top and makes cleanup easier.
Daily use of ceramic cooktop
cleaner will help keep the cooktop
looking new.
^ Shake the cleaning cream well.
¥
Apply a few drops of ceramic
cooktop cleaner directly to the
cooktop.
Use a paper towel or cleaning pad
for ceramic cooktops to clean the
entire cooktop suiface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It Is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Use a cleaning pad for ceramic
cooktops.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur If you use scrub pads other than the
pad included with your cooktop.
Allow the cooktop to cool.
Spread a few drops of ceramic
cooktop cleaner on the entire
burned residue area.
Using the included cleaning
pad for ceramic cooktops, rub the
residue area, applying pressure
as needed.
^ If ant' residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, jtolish
the entire surface with ceramic
cooktop cleaner and a paper towel.
The ceramic cooktop scraper
and all recommended supplies are
available through our Parts Center.
See Instructions under “To Order
Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
Allow the cooktop to cool.
7
LJse a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface
atid scrape the soil. It will be
necessaiy to apply pressure to
the razor scraper in order to
remove the residue.
After scraping with the razor
scraper, spread a few drops of
ceramic cooktop cleaner on the
entire burned residue area. Use the
cleaning pad to remove any
remaining residue.
For additional protection,
after all residue has been
removed, ¡rolish the entire
surface with ceramic cooktop
cleaner and a paper towel.
7 5