Kenmore 110.4646 - Manual (Page 11)

1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose in the laundry tub or standpipe as
shown. See illustrations A and B.
B C
4. If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
NOTES:
■ Do not force excess drain hose back into the rear of the washer.
■ To avoid siphoning, do not seal the drain hose into the
standpipe.
One foot has been installed at a different height on your new
washer. The other three feet were preset at the factory. Properly
leveling your washer will minimize excessive noise and vibration.
1. Push on the upper front panel to be sure that the washer is on
the rear feet. Lower right front foot until it contacts the floor.
Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
3.
4.
5.
6 .
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
Make sure that all four feet are stable and resting on the floor.
Then check that the appliance is perfectly level (use a level).
After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
When you are pushing on the edges of the washing machine
top plate, the machine should not move front to back, side to
side, or diagonally.
Slide the washer to its final location.
Confirm the levelness of the washer.
1 .
3.
4.
5.
6
.
Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.’’
Check that all parts are now Installed. If there is an extra part,
go back through the steps to see which step was skipped.
Check that you have all of your tools.
Dispose of or recycle all packaging materiais.
Check that the water faucets are on.
Check for leaks around fauoets and inlet hoses.
AWARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Read “Washer Use.”
9. To test and to clean your washer, using only “HE” High
Efficiency detergent, measure the amount of detergent
recommended by the manufacture for a medium size load.
Pour the detergent into the detergent dispenser. Select
NORMAL/CASUAL, and then select START. Allow the washer
to complete one whole cycle.
m
Use only HE High Efficiency detergent.
11