Kenmore ASPIRADORA 116.29914 - Manual (Page 25)

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Constant green light on
in dirt sensor. 1. Dirt passage is dogged
2. Lenses are dirty
1 Check for dogs in air passages,
2, Clean lenses.
No green or red dirt
sensor lights. 1. Switch not in CARPET position,,
2. No power to sensor board.
1, Move switch to CARPET position
2- Take to your nearest Sears Service
Center,
CHECK BAG Indicator
activates,
1. Full or dogged dust bag
2. Dirty fiilers
3. Blocked airflow passage
4. Certain attachment tools
1, Change bag
2. Change fiiters
3. Clear blockage from airflow passage
4, This is norma! Light should go off
when tool is removed.
Vacuum cleaner picks
up moveable rugs "or*
PowerMate pushes too
hard.
1, Wror?g pile height setting
2. Suction too strong
1, Adjust setting.
2 Select lower Power Level
Red light for BELT
RESET {overload
protector) is lit on the
PowerMate, 1, Tripped overload protector in
PowerMate,
1. Remove any items that may be
caughlor jammed, then reset. If
vacuum cleaner starts and stops
again, dean agitator and end caps,
then reset
Cord won’t rewind. 1. Dirty power cord
2. Cord Jammed
1, Clean the power cord
2. Pul! out cord and rewind
Vacuum cleaner leaves
marks on carpet.
1. Wrong vacuuming pattern 1, See VACUUMING TIPS
25