Kenmore 631 - Manual (Page 14)

DUST BAG CHANGING
TO REMOVE DUST BAG
A
WARNING
Always unplug power cord from elec­
trical outlet before performing any
service on vacuum.
Pull out on the
bag cover
release located
near the top of
the bag cover.
Bag Cover
Release
Pull the bag
cover forward
and lift up.
Remove and
lay aside.
Grasp the dust bag
collar and pull gen- \
tly, carefully remov­
ing the dust bag.
Throw away the
used dust bag.
Do not reuse.
Bag Holder
Check the bag
holder and the
Bag Cavity motor safety fil­
ter. If either is
blocked, check
TROUBLE­
SHOOTING,
Motor
Safety
Filter
A
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh­
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu­
uming these materials.
Safely
Seal Tab
TO REPLACE DUST BAG
Unfold the
new dust bag.
Fold the safety
seal tab on the
new dust bag
away from the
opening that
fits on the bag
holder.
NOTE: See PARTS AND FEATURES for
Bag number.
Insert the dust bag
onto the bag holder
completely by holding
the bag collar.
Tuck the bag
behind each of
the four bag
retention corner
flaps shown here.
Be sure the bot­
tom and sides of
the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Place the dust bag
collar into position.
Sag
Retention
Corner
Flaps
Position the bag
cover so its
positioning tabs
fit into the body
positioning tab
slots.
cover.
You will hear a
distinct snap
when cover is
securely closed.
Check to see
that the dust bag
is fully enclosed in the bag cover.
b ;I
14