Warning, Electrical shock or personal injury hazard, To remove belt – Kenmore 631 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit. Failure
to do so could result in electrical
shock or personal Injury from cleaner
suddenly starting.
Frequently check and remove hair, string
and lint build-up in the brush area. If
build-up becomes excessive, follow the
steps below.
TO REMOVE BELT
Disconnect power cord from electrical
outlet.
Carpet/Bare
Floor Selector
To Carpet
Position
\
.
Place the
carpet/bare
floor selector
in the carpet
position.
Slide latches
outward and
remove nozzle
cover.
Nozzle
Cover
Furniture
Guard
Retainer
Agitator
Cover
Unfasten the
furniture
guard retain
ers from the
posts on
both sides of
the agitator
cover.
Agitator
Cover
Depress tabs
on rear of agita
tor cover and
rotate forward
to release from
the nozzle
body.
The light bulb socket assembly does not
have to be removed. Lay the agitator
cover over to the side out of the way.
Agitator
Position hands on the agitator. If the belt
is still attached to the agitator, there will
be tension on the agitator. Carefully lift
the right end of the agitator and then the
left end,
NOTE:
It may be necessary to pull the
edge of the furniture guard out of the way
to allow the ends of the agitator to be
removed easily.
Remove the belt from the motor drive
shaft.
A spare belt is provided. See above illus
tration for location of spare belt. You may
keep a spare belt in this location any
time.
A
WARNING
Personal Injury Hazard
Be careful when removing the agita
tor as the belt tension is high. Failure
to do so could result in personal
injury from the agitator releasing
quickly and snapping away.
16