Back burner lighting instructions, A warning, Warning – Kenmore 141.17337 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Back Burner Lighting Instructions
Note: The location of the Back Burner makes it more
susceptible to winds that will decrease the perfor
mance of your rôtisserie cooking. For this reason you
should not operate the Back Burner during windy
weather conditions.
1. If you have a LP gas grill be sure the LP gas tank
is filled, or if you have a NG grill be sure that the
locking shut off valve is open.
2. Check that the end of each Burner Tube is
properly located over each Valve Orifice.
3.
Be sure all gas connections are securely tightened.
4. Open the Grill Lid. Failure to do so can result in
fire or explosion. See WARNING below.
8. If the burner does not light, turn the control knob to
OFF, wait 5 minutes for gas to clear, then retry.
9- Once lit, the Back Burner will reach cooking
temperature quickly. The orange/red glow wilt
even out in about 5 minutes.
10. For best results, always rôtisserie cook with the
grill lid down and the Back Burner control knob set
to ON. Do not use the main grill burners when the
Back Burner is in operation.
A
WARNING
Failure to open Grill Lid during the
lighting procedures could result in a fire
or explosion that could cause serious
bodily injury, death, or property damage.
5.
Set ALL Control Knobs to OFF and open the LP
gas tank valve slowly until 1/4 to 1/2 open.
Open LP
gas tank
OFF
6.
Push and turn the Right Control Knob for Back
Burner to ON.
ON
Immediately press the Right Electric Ignitor
for 3-4 seconds to light the Back Burner.
RIGHT ELECTRIC
IGNITOR
25