Refrigerator use, Refrigerator safety – Kenmore 106.511800 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Please read before using the water system.

Immediately after installation, follow the steps below to make

sure that the water system is properly cleaned.

1. Open the freezer door and turn off the ice maker. The On/

Off switch con only be accessed when the ice storage bin

has been removed. The switch is located on the freezer door,

on the left side of the wall that surrounds the ice storage bin.

Move the switch to the OFF (right) setting.

2.

Make sure the water filter is properly installed.

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain

filterable cysts.

3.

Flush the water system. Use a sturdy container to depress

and hold the water dispenser lever for 5 seconds, then

release it for 5 seconds. Repeat until water begins to flow.

Once water begins to flow, continue depressing and

releasing the dispenser lever (5 seconds on, 5 seconds off)

until a total of 3 gal. (12 L) has been dispensed. This will

flush air from the filter and water dispensing system, and

prepare the water filter for use. Additional flushing may be

required in some households. As air is cleared from the

system, water may spurt out of the dispenser.

4.

Open the freezer door and turn on the ice maker. Move the

switch to the ON (left) position. Please refer to the “Ice

Maker and Storage Bin” section for further instructions on

the operation of your ice maker.

Allow 24 hours to produce the first batch of ice.

Discard the first three batches of ice produced.

Depending on your model, you may want to select the

maximum ice feature to increase the production of ice.

Your new refrigerator may make sounds that your old one didn’t

make. Because the sounds are new to you, you might be

concerned about them. Most of the new sounds are normal.

Hard surfaces, such as the floor, walls, and cabinets, can make

the sounds seem louder. The following describes the kinds of

sounds and what may be making them.

If your refrigerator is equipped with an ice maker, you will

hear a buzzing sound when the water valve opens to fill the

ice maker for each cycle.

Your refrigerator is designed to run more efficiently to keep

your food items at the desired temperatures and to minimize

energy usage. The high efficiency compressor and fans may

cause your refrigerator to run longer than your old one. You

may also hear a pulsating or high-pitched sound from the

compressor or fans adjusting to optimize performance.

You may hear the evaporator fan motor circulating air

through the refrigerator and freezer compartments. The fan

speed may increase as you open the doors or add warm

food.

Rattling noises may come from the flow of refrigerant, the

water line, or items stored on top of the refrigerator.

Water dripping on the defrost heater during a defrost cycle

may cause a sizzling sound.

As each cycle ends, you may hear a gurgling sound due to

the refrigerant flowing in your refrigerator.

Contraction and expansion of the inside walls may cause a

popping noise.

You may hear air being forced over the condenser by the

condenser fan.

You may hear water running into the drain pan during the

defrost cycle.

REFRIGERATOR USE

Single Evaporator (on some models)

In order to ensure proper temperatures, you need to permit air

to flow between the two sections. Cold air enters the bottom of

the freezer section and moves up. It then enters the refrigerator

section through the top vent. On Style 2 models, this air is also

evenly distributed throughout the refrigerator compartment

through six vents on the back wall. Air then returns to the freezer

as shown.

Style 1

Style 2

i i

! * :

f ------------

-----------

¥

i

f

f

-------------

Do not block any of these vents with food such as soda, cereal,

bread, etc. If the vents are blocked, airflow will be obstructed

and temperature and moisture problems may occur.

IMPORTANT: Because air circulates between both sections, any

odors formed in one section will transfer to the other. You must

thoroughly clean both sections to eliminate odors. To avoid odor

transfer and drying out of food, wrap or cover foods tightly.

Dual Evaporator (on some models)

Some models come equipped with a dual sequential

evaporation system, which includes two separate evaporators

for the refrigerator and freezer compartments.

15

Advertising