Kenmore 106.511800 - Manual (Page 21)

■ Do not use anything sharp to break up the ice in the storage
bin. This can cause damage to the ice container and the
dispenser mechanism.
■ Do not store anything on top of or in the ice maker or
storage bin.
Turning the Ice Maker On/Off:
The On/Off switch can only be accessed when the ice storage
bin has been removed. The switch is located on the freezer door,
on the left side of the wall that surrounds the ice storage bin.
See the following section for bin removal instructions.
Ice Maker Control
■ To turn on the ice maker, slide the control to the ON (left)
position.
■ To manually turn off the ice maker, slide the control to the
OFF (right) position.
NOTE: The ice maker has an automatic shutoff to keep the
storage bin from overfilling during normal operation. The ice
maker sensors will automatically stop ice production, but the
control will remain in the ON (left) position.
Removing and Replacing Ice Storage Bin:
1. Press down the release lever and tilt the bucket outward. Use
both hands to hold the base of the storage bin, then lift it up
and out.
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The
sensor cover (“flipper door”), located on the right wall of the
freezer door, stops the ice maker from producing ice if the
door is open or the storage bin is removed.
B
2. Replace the bin by sliding it onto the door, then tilting it
back into an upright position. The release lever will click
when the bin is securely in place.
REFRIGERATOR FEATURES
Your model may have some or all of these features. Features
that can be purchased separately as product accessories are
labeled with the word “Accessory.” Not all accessories will fit all
models. If you are interested in purchasing one of the
accessories, please call the toll-free number on the back cover
or in the “Accessories” section.
Important information to know about giass sheives
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many smaii,
pebbie-size pieces. This is normai. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
To Remove and Replace the Bins:
1. Remove the bin by lifting it and pulling it straight out.
2. Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
21