Kenmore 790.16777 - Manual (Page 16)

Option Selections
You can customize your cycles by pressing an option. If
you change your mind, press the option again to turn the
option off. Select a different option if desired.
You can change an option anytime before the selected
option begins. For example, you can press an unheated
drying option any time before drying begins.
Press START to use the same cycle and option(s) as the
previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle,
when you press Start, the dishwasher runs the last full
wash cycle and options.
Water Heat
Select this option to heat the water to 140°F (60°C) during
parts of the cycle. (See the Cycle Chart.) Heating the water
helps improve washing results. This option adds both heat
and wash time to parts of the cycle.
f WATER I
I
HEAT
I
NOTE: Pots Pans automatically uses this option. Water
Heat is an option with the Normal Wash and Water Miser
cycles.
No Heat Dry
Select this energy-saving option to dry without heat. No
Heat drying is useful when loads contain plastic
dinnerware that may be sensitive to high temperatures.
NO HEAT I
The dishes take longer to dry and some spotting can
occur.For best drying, use a liquid rinse aid. Some items
(such as plastics) may need towel drying,
NOTE: Quick Rinse automatically use this option. No Heat
Dry is an option with all other cycles.
Control Lock On
Use the Lock to prevent your dishwasher from accidentally
being turned on. Use the Lock, also, to prevent accidental
cycle or option changes during a cycle.
L ock O n
When LOCK ON is lit, all buttons are disabled.
NOTES:
■ The dishwasher door can be opened while the controls
are locked.
■ You can turn on the Lock while the dishwasher is
running.
To turn on the Lock
Press and hold
for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the
light flashes 3 times.
To turn off the Lock
Press and hold NO HEAT DRY for 4 seconds. The light
turns off.
Delay Hours
Select this option to run your dishwasher at a later time or
during off-peak hours.
To delay the start
1. Close the door.
2. Select a wash cycle and options.
3. Press DELAY HOURS 1 time for a 2-hour delay, 2 times
for a 4-hour delay, or 3 times for a 6-hour delay.
HOURS
2 4 6
f DELAY
I HOURS
The number glows above Delay Hours. The dishwasher
starts the cycle in the selected number of hours.
4. Press START.
NOTE: To cancel the delay, press CANCEL/DRAIN until all
Delay Hours lights are off.
IMPORTANT:
■ Operate your dishwasher only when you are at home.
■ If your home is equipped with a water softener, do not
start the dishwasher during the regeneration of the
softener.
16