Heavy duty with soak, Bulky/bedding, Normal – Kenmore W10026675A User Manual

Page 2: Casual, Delicate, Prewash, 2nd rinse, Rinse & spin, Spin only, One rinse

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CfCLi SILECTil fTIlill CilTliL
Estimated cycle time based on a full load with a Regular Soil Level setting.

Heavy Duty with Soak

Use this cycle for sturdy or heavily soiled loads. This cycle
includes a 5-minute soak to help improve cleaning.
• Approximate cycle time: 50 minutes

Bulky/Bedding

Use this cycle for large non-absorbing items such as comforters,
pillows, and jackets, or for spandex items. This cycle will add more

water in the initial fill to provide saturation for less absorbent items.

• Approximate cycle time: 45 minutes

Normal

Select this cycle for cottons and linens used regularly.
The fast-speed spin shortens drying time.
• Approximate cycle time: 40 minutes

Casual

Select this cycle for synthetic fabrics such as dress shirts,
blouses, and slacks, the cycle will give you a load-cooling
spray rinse to reduce wrinkling.
• Approximate cycle time: 40 minutes

Delicate

This cycle combines slow-speed agitation and slow-speed
spin to gently clean garments while reducing wrinkles.

• Approximate cycle time: 35 minutes

Handwash

Use this cycle for special care items. This cycle features a

series of brief agitations and short soaks for gentle cleaning
and minimal wrinkling.

• Approximate cycle time: 30 minutes

Soak

This cycle features agitation followed by unlimited soak time to help
remove stains that need pretreatment. After soaking, you have two
options. To use the same water in a wash cycle, advance the Cycle
Selector (Timer) Control knob to a wash cycle. To remove the soak
water, reset the washer to a Spin setting, ft the Soak water was
drained, add more detergent to the wash cycle.

NOTE:

Be sure to push the control in to change to another cycle

and set. Pull the control out to start the washer in its selected cycle.

Prewash

This cycle helps to remove heavy soils that need pretreatment.
This cycle should be followed by a wash cycle. Add more detergent
to the wash cycle. The Prewash cycle does not include a rinse.

• Approximate cycle time: 15 minutes

2nd Rinse

A second rinse can be used to aid in improved removal of detergent
or bleach residue from garments. This option may be automatically
added to the wash cycle by setting the OPTIONS Control to 2nd

Rinse anytime before the end of the cycle.

Rinse & Spin

Select this option if you fhink an extra rinse is needed. Set OPTIONS
Control to 2nd Rinse. You should then set the Cycle Selector (Timer)
Control knob to a 2nd Rinse setting.

Spin Only

A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set OPTIONS Control (if avaiiable)
fo One Rinse. You should fhen sef Cycle Selector (Timer) Confrol
to a Spin seffing.

iJiST

Use the Heavy Soil selection for toads fhaf need a more fhorough cleaning. Use fhe Regular Soil selecfion tor garmenfs fhaf are normally

soiled. Use Lignf Soil for garments that are only lightly soiled or require a little care.

OPTIONS

One Rinse

2nd Rinse

This is the rinse at the end of each cycle.

Choose this option for an automatic 2nd rinse cycle.

TiOUBLESHOOTIiG - SOUiDS anil LEMS

Before you call service...check for the following.

Loud clicking and banging?

• The yellow shipping strap may still be in the rear of the

washer. Completely remove the yellow shipping strap.

• The washer should be level, and the feet should be firmly

on the floor.

Some sounds are normal but may be different from
those of your previous washer.

• The gears engaging after the drain and before the spin.

• The sound of air being pulled through the pump after most

of the water has drained.

Is the washer leaking?

• Fill hose connections are tight.

• Gaskets in fill hose are tight and flat.

• Drain hose clamp is securely attached.

• Faucets, drain/standpipe or laundry tub is not leaking.

• The washer tub is centered, and the load evenly balanced

at the start of each load.

• The washer is level.

• The front feet are installed, and the nuts are tightened

to the cabinet.

See the Use and Care Guide for complete details.

W10026675A

© 2008 Sears Brands, LLC.

® Registered Trademark /TM Trademark / SM Service Mark of

Sears Brands, LLC, used under iicensee by Sears Canada Inc.

7/08

Printed in U.S.A.

Advertising
This manual is related to the following products: