Installation instructions (cont’d), Installation checklist – Kenmore 153.327366 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions (cont’d)
installation Checklist
Whether or nor the eiement conversion is made, the model
rating plate must be marked. Using a hard point ink pea,
check the appropriate block within the model rating plate,
■which is located adjacent to the lower access panel.
Is the fuse or circuit breafter size correct as shown in the chart
in the “Product Specifications” section?
Are the wires from die circuit breaker or fuse service to the
water heater's juncrion box on the correct wire size (gauge) as
shown in the chart in the “Product Specifications” section?
Is the new temperature-pressure relief valve properly
installed, and piped to an adequate drain? See “Temperature-
Pressure Relief Valve" section,.
Is the water heater completely filled with water? See “Filling
the Water Heater” instructions in the “installation
Instructions” section
WiU a water leak damage anything? See “Facts to Consider
About the Location” section-
Are the cold and hot water lines connected to the water heater
correedy? See “Water Piping” instructions in the “Installation
Instructions" section,
is there adequate clearance for maintenance around the water
heater?
Do you need to call your electric compan'y to check your
wiring?
TEMPERATURE-
PRESSURE
RgLlEF VALVE
»PJiiWHAKiafc rirlc
(Do not cap or plug)
6 ' AIR GAP
FLOOR DRAIN
t
V-» TV »-F rVrA 11 *
” :■ ■■¡miCVWrcfHEATER ECO
i mN US’ »TAuej
«MTS hENIKM
mXKX Ik
1 Ul 1 ^ ^
uv>n Mtunm xtBy CAPAEirr
FACIW EOUIPPHiWtM ua.uAL,. ^ ^ ^
fSunSi nSiiSfr «bMtiMuw varaaewwùwittttiNt
...rzn
f 150
«»TT9 WATTS ìVATin AXi. c;ini.T
if
fNlSTALLLU <<
emjKALWAraoE ■ pAii?tifìVHQUiP!
■‘SIA ¿gSr MMat!»-,eteau,aHEHE,'-,j ■ •
^rrTST“™“
up
I
" SEECONVESiSiaH
iKSITWnO«
mrm
WA1T0 wATfa.-.
MODEL
ka
TING
plate
15