Kenmore 153.327366 - Manual (Page 8)

Installation Instructions (cont’d)
Water Piping
AWARNING
HOTTER WATER CAN SCALD: Water heaters are
intended to produce hot water. Water heated to a tem­
perature which will satisfy space heating, clothes washing,
dish washing, and other sanitizing needs can scald and
permanently injure you upon contact. Some people are
more likely to be permanently injured by hot water than
others. These include the elderly, children, the infirm, or
physicaltyimentaily handicapped. If anyone using hot
water in your home fits into one of these groups or if
there is a local code or state law requiring a certain tem­
perature water at the hot water tap, then you must talee
special precautions. In addition to using the lowest possi­
ble temperature setting that satisfies your hot water
needs, a means such as a mixing valve, shall be used at
the hot water taps used by these people or at the water
heater. Mixing valves are available at plumbing supply or
hardware stores. Follow manufacturers Instructions for
installation of the valves. Before changing the factory set­
ting
on the thermostat, read the “Temperature
Regulation“ section in this manual.
The iJlusrration shows the arcachmenc of the waier piping to the
water heater. The water heater is equipped with water
connections.
If a water heater is mstaJled in a dosed water supply system;
such as one having a back-flow preventer, chedt valve, water
meter with a check valve, etc. in the coid water supply; means
shall be provided to control thermal expansion. Contact the
local utility or local Seats Service Center on how to control this
situation.
NOTE: If using copper tubing, solder tubing to an adapter
before attaching the adapter to the cold water inlet connec­
tion. Do not solder the cold water supply line directly to the
cold water irdet. It will barm the dip tube and damage the
tanlc
• Look at the top cover of die water heater. The water outlet is
marked hoc Put two or three turns of teflon tape around the
threaded end of the threaded-to-sweat coupling and around
both ends of the X" threaded nipple. Using flexible connec­
tors, connect the hot water pipe to the hot water outlet of the
water heater
• look at the top cover of the water heater, The cold water inlet
is marked cold. Pur two or three turns of teflon tape around
the threaded end of the threaded-to-sweat coupling and
around both ends of the threaded nipple. Using flexible
connectors, connect the cold water pipe to the cold water
inlet of the water heater.
NOTE: Your water heater is super insulated to minimize
heat loss from the tanit. Further reduction in heat loss can be
accomplished by Insulating the hot water lines from the
water heater.
Iiistaliation completed using Seat's
Installation Kit
PI if EXI B'LK
3/4 " THREAOE0
NIPPLE