Kenmore 625.38156 - Manual (Page 18)

How Your RO Water System Works
HOW YOUR REVERSE OSMOSIS SYSTEM
WORKS
Introduction:
Your Reverse Osmosis (RO) Drinking
Water System uses your household water pressure to
force water through three filters. Minerals and impurities
are filtered out. Delicious tasting drinking water goes to
the storage tank-ready for your use. Minerals and impu­
rities are sent down the drain. The following paragraphs
will explain in detail how your Reverse Osmosis
Drinking Water System works.
Prefilter: Water from the cold supply pipe enters the pre­
filter. See Figure 24. The prefilter has a replaceable sedi­
ment cartridge with activated carbon in its composition.
The cartridge reduces taste, odor, sand, silt, dirt, other
sediments, and up to the amount of chlorine shown in
the specifications.
Reverse Osmosis Cartridge: Filtered water flows from
the prefilter, to the Reverse Osmosis membrane car­
tridge. See Figure 24. The Reverse Osmosis cartridge is a
tightly wound special membrane. The membrane
reduces the dissolved solids and organic matter. High
quality product water (about one ounce per minute) exits
the Reverse Osmosis cartridge. The product water flows
to the storage tank, postfilter or Reverse Osmosis faucet.
See Figure 24. Reject water, with the dissolved solids and
organic matter, is routed to the drain. See Figure 24.
Storage Tank: The storage tank holds product water. See
Figure 24. A diaphragm inside the tank holds water pres­
surized to about 30 psi when the tank is full. This pro­
vides fast flow to the Reverse Osmosis faucet. When the
tank is empty of water, it is pressurized to 5 - 7 psi.
Postfilter: Before going to the Reverse Osmosis faucet,
product water goes through the postfilter. See Figure 24.
The postfilter is an activated carbon type filter. Any
remaining tastes and odors are reduced from the prod­
uct water. Clean, high quality drinking water is available
at the faucet.
Reverse Osmosis Faucet: The sink or countertop faucet
has a hand operated knob to access drinking water. See
Figure 24. An air-gap is built into the faucet drain water
connection to comply with plumbing codes. See Figure
24.
Faucet Electronics: Inside the faucet base is a battery
operated 6 month timer. See Figure 14. An amber LED
indicator is also located in the front of the faucet base.
This LED will flash continuously after 6 months have
passed. This indicates that it is time to replace the bat­
tery, prefilter and postfilter.
Shutoff Assembly: The unit has an automatic shutoff
system to conserve water. When the storage tank has
filled to capacity, and the drinking water faucet is closed,
pressure closes the shutoff to stop flow to the drain.
After enough drinking water is used, pressure in the sys­
tem drops, and the shutoff opens to allow the tank to be
refilled. See Figure 24.
Check Valve: A check valve is located in the Reverse
Osmosis manifold, above the center sump. The check
valve prevents a backward flow of product water from
the storage tank to drain. A backward flow could dam­
age the Reverse Osmosis Membrane. See Figure 24.
Flow Control: Water flow to the drain is restricted by the
flow control. It maintains the desired flow rate to obtain
the highest quality drinking water. The flow control is
located in the end of the 1/4" red drain tubing, at the
Reverse Osmosis manifold drain port. See Figure 24.
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
18