Wash and dry – Kenmore 114.85925 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fill remainder of Clean
Water Tank with warm
water up to the MAX
FILL line. Replace
measure cap on Clean
Water Tank.
Replace Tank-in-Tank"
System by inserting
bottom first and tilting
forward until tank
latch fastens.
WASH AND DRY
With dry hands, plug
cord into properly
grounded electrical
outlet.
Step on No
2
:zle Setting
pedal if necessary to
switch from HARD
FLOOR DRY VAC to
WET SCRUB & VAC.
Turn cleaner on by
moving power on/off
switch from OFF to
ON.
Step on Handle
Release pedal to put
into cleaning position.
Slide Brush On/Off
switch to the ON
position.
Pull Solution Trigger
to start the flow of
cleaning solution.
NOTE;
Cleaner will
continuously
dispense solution
until Solution Trigger
is released.
With Solution On/Off
trigger held down,
slowly push unit
forward. Release
Solution On/Off
trigger and pull unit
backward in same
area to remove dirty
water and solution
from carpet. (For
heavily soiled areas,
repeat if necessary).
To aid in the drying
process, slide Brush
On/Off switch to OFF
position and continue
operating in WET
SCRUB & VAC mode.
IMPORTANT:
If the unit stops picking up
dirty water and/or the motor changes to a
high pitch, the dirty water tank is full and
must be emptied. See page 13.
12