Element cleaning/ drain valve washer, Replacement (cont’d) replacement, Service – Kenmore POWER MISER 153.327164 User Manual
Page 20: Service and adjustment (cont’d)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Element Cleaning/
Drain Valve Washer
Replacement (cont’d)
Replacement
Service and Adjustment (cont’d)
16, Replace terminal cover on thermostat making sure that the
locking tabs on the terminal cover are in place.
17. Replace the insulation block so that it completely covers the
thermostat and element.
NOTE; For replacement, use a x ”/«" x V»" thick washer
available at your nearest hardware store. For ordering a
replacement washer, refer to the “Parts Order List” section.
• Before beginning turn “OFF” the electrical power supply to
the water neater.
18, Replace access panel.
19. Turn “ON” electric power to water heater.
AWARNING
HAZARD
OF
ELECTRICAL
SHOCK!
Before
removing
any access panels or servicing the water heater, make
sure the electrical supply to the water heater is turned
“OFF”. Failure to do this could result in DEATH, SERI
OUS BODILY INJURY, OR PROPERTY DAMAGE.
• Follow “Draining” instructions. See “Draining” section.
• Turning counter clockwise, remove the hex cap below the
screw handle.
• Remove the washer and put the new one in place,
• Screw the handle and cap assembly back into the drain valve
and reiighten using a wrench. DO NOT OVER TIGHTEN.
• Follow “Filling the Water Heater” instructions in the
“Installation Instructions” section.
• Check for leaks.
• Turn “ON” electric power to the water heater.
Service
Before calling for repair service, read the Start Up Conditions
and Operational Conditions found in the Troubleshooting
Guide of this manual.
If a condition persists or you are uncertain about the operation
of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at 1-800-4-MY-HOME
(1-800-469-4663).
20