Kenmore 580.75116 - Manual (Page 7)

INSTALLATION
If you are using the new sleeve (optionally
supplied with your unit),skip to step 3.
Otherwise, install the plastic grille from the kit.
Cut the plastic grille to 25-1/2'’ wide and
15-1/4" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
procedure a
Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressing into the square holes
of the rear flanges.
FIG. 5
Remove the backing from the Vertical
Insulation strip 15®/16 x 1% x l^/s and attach that
to the inside right of the sleeve as shown
below. Remove the backing from the Around
insulation strip 67Vs x 13/g x 25/32 and attach that
to the inside front of the sleeve as shown
below.
Indoor Outdoor
9 Vo" 6 "
FIG. 6
n Remove the metal rear grille and replace it with
“ the plastic rear grille to improve unit energy
efficiency. The plastic grille reduces the amount of
hot air discharge that recirculates through the unit.
install the new unit Into the wall sleeve.
To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim Is flush with sleeve as shown below.
FIG. 8
A CAUTION
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to avoid
cuts from sharp metal fins on front and rear coils.
• Make sure air conditioner does not fall during
removal.
• if unit does not operate after installation check, to be
sure the circuit interrupter has not been tripped. Refer
fo the Troubleshooting guide for reset procedure.