Kenmore Water System - Manual (Page 5)

Ls
j j j j j j :
SECTION 1
ij jj :^. м . м j jj :^.^ ' '
BEFORE INSTALLING CHECKS & TESTS
B. UNPACKING THE WATER SOFTENER
Directions for unpacking the softener are on the top
of the shipping carton. This manual, and the own­
er's manual, were in the small parts bag. You will
need the small parts to install the softener. Keep
them in the bag until you are ready to use them so
you don't lose any parts. Remove all other card­
board pieces, foam packings, tapes, etc. from the
softener and discard.
Check the softener for shipping damage. If you
find damage, report it to your Sears store.
Use care when handling the softener. DO NOT turn
upside-down. DO NOT drop, or set on sharp objects
that could make a hole in the bottom. The water soft­
ener is heavy and to avoid damage, or personal inju­
ry, do not try to lift it or move more than necessary.
See page 3-4, when you are ready to move it into
installation position.
FIG. 1
PARTS DESCRIPTIONS SMALL PARTS
FACE
PLATE
I
in<; installation manual
n
owner’s manual bypass valve
(included with some models)
copper
tubes (2)
gaskets (2)
installation
nut (2)
tube
clamp (2)
drain hose ground clamp kit
tube
adaptor
grommet
1-2 Deluxe Valve
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line