Lock on, Clean, Sanitized (on some models) – Kenmore ULTRA WASH 665.77925 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Lock On

#f :

mm

I mJM.rCm.

Use the Lock On to avoid unintended use of the dishwasher. You
can aiso use the iock feature to avoid unintended cycie or option
changes during a cycie.

When LOCK ON is iit, aii buttons are disabied.

NOTE: The dishwasher door can be opened whiie the controis
are iocked. However, the iock must be turned off and the Start/
Resume button pressed to resume the cycie.

To turn on the Lock

Press and hoid HEATED DRY for 3 seconds. LOCK ON giows.
if you press any pad whiie your dishwasher is iocked, the iight

fiashes 3 times.

NOTE: if the Heated Dry option is seiected, the iight wiii

temporariiy turn off until Lock On glows.
To turn off the Lock

Press and hold HEATED DRY for 3 seconds. The light turns off.

Delay Hours

Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay. After adding items, firmly close the door until it latches and
press START/RESUME, or the delay will not continue.

To delay the start

1. Press the delay button to choose the number of hours

delayed.

2. Select a wash cycle and options.

3. Press START/RESUME.

The dishwasher starts the cycle in the selected number of hours.

NOTES:

■ To cancel the delay and cycle, press CANCEL/DRAIN.

■ To cancel the delay and start the cycle, press START/

RESUME.

Follow the progress of your dishwasher with the Cycle Status
indicators.

®

Washing Drying Clean Sanitized

NOTE: The features on your dishwasher may vary from those

shown here.

Clean

Clean glows when a cycle is finished. The light turns off when you
press any button or close the door.

Sanitized (on some models)

If you select the Sani Rinse option. Sanitized glows when the
Sani Rinse cycle is finished. If your dishwasher did not properly

sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted or the incoming water
temperature is too low. The light turns off when you press any

button or close the door.

During cycles, the vent allows vapor to escape into the room.
Between cycles, the vent allows airflow, reducing the buildup of
odors.

P

\

V N

\ N

\ \

I I

:—i~r

IMPORTANT: The vapor is hot. Do not touch the vent
during drying.

0¥€irill Protection Float

The overfill protection float (in the front right corner of the

dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.

Check under the float for objects that may keep the protector
from moving up or down.

13

Advertising
This manual is related to the following products: