Kenmore 141.166801 - Manual (Page 13)

Calibration Procedure.
1. Before installing batteries be sure the gas tank is not
mounted in the tank pull-out tray.
2. From the underside of the Control Panel, unscrew the
Fuel Gauge Display Cover on the Fuel Gauge Display
Box. See Fig.6a
3. Carefully remove the battery box from the back of the
Fuel Gauge Display Box and insert two "AAA" batter­
ies (provided). Be su re to follow correct pol arity when
inserting batteries.
4. Return the Battery Box with electric wire into the Fuel
Gauge Display Box.
5. Screw the Fuel Gauge Display Cover onto the Fuel
Gauge Display Box.
Figure 6a
IMPORTANT: When the gas tank is removed from
the tank pull-out tray, the fuel gauge display will not
operate.
6. During calibration the Fuel Gauge Display shows the
tank images of FULL and then EMPTY quickly.
IMPORTANT: When changing batteries or re­
connecting Plug “A” and “Plus “B” See Fig.6b,,
be sure to remove the gas tank from the tank pull­
out tray.
Fuel Gauge Display Operating - See Fig. 6c
Press the “CHECK” button to operate Fuel Gauge Dis­
play with the gas tank mounted in the Tank Pull-Out Tray.
NOTE: Tank must be positioned in tray for Fuel
Gauge Display check
1. Fuel Display: Indicates gas tank fill level.
2. Fuel Warning Display: When the gas tank fill level
is on the last row, a warning signal will sound for
approximately 3 seconds to warn you that the tank
volume is near empty.
3. Battery Warning Display: A low battery warning
light will illuminate when the battery voltage drops to
a low level. Replace the batteries.
NOTES:
1. The Fuel Gauge Display lasts for approximately 20
seconds each time you press the “CHECK” button.
After 20 seconds, the Fuel Gauge Display turns off
automatically. If you press the button a second time
within 20 seconds, the Fuel Gauge Display will be
turned off manually. If you press the button a second
time after 20 seconds, the Fuel Gauge Display will
work and last for another 20 seconds.
Figure 6b
‘CHECK
SUTTON
2. The Fuel Gauge Display works only with a tank on
the Tank Pull-Out Tray. No readout will appear if a
tank is not mounted on the Tank Pull-Out Tray.
13