Disconnecting a liquid propane gas (lp gas) – Kenmore 141.166801 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1. Remove the Pull-out Grease Draining Tray with the

Heat Shield from Grill.

2. Locate hose and regulator assembly packed for

shipping purposes on front underside of grill head.
Remove fastening band. Push assembly to back of
grill and pull down to connect to tank valve. Before
connecting, check valve and assembly threads to
be sure they match. {Tj^e 1 connection per ANSI
Z21.58a-1998)SeeFig.7b.

3. Inspect the valve connection port of the regulator

assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use
damaged or plugged equipment.

4. Pull out the LPG Tank Pull-out Tray. Place a

20 lb tank with foot ring into the hole in the
tray. See Fig.7a. Make sure the tank valve is
in the OFF positon.

5. Align the tank so the Tank Valve faces the rear

right corner of cabinet. Use the 516"x89mm Wing
Bolt to secure gas tank from rear of tray.
^5ee Fig. 7a.

6. Check the tank valve to ensure it has proper

external mating threads to fit the hose &
regulator assembly provided (Type 1 connec­
tion per ANSI Z21.58a-1998). See Fig.7b

7. Make sure all Burner knobs are in the OFF

position.

8. Connect the hose and regulator assembly to the

tank valve (See Fig 7b) Hand tighten Quick Cou­
pling Nut clockwise to a full stop. DO NOT use a
wrench to tighten because it could damage the
Quick Coupling Nut and result in a hazardous
condition.

9. open the tank valve fully (counterclockwise). Use a

soapy water solution to check all connections for
leaks before attempting to light your grill. See
"Checking for LP Gas Leaks" on page 15. If a leak
is found, turn the tank valve off and do not use your
grill until the leak is repaired.

Disconnecting A Liquid Propane Gas (LP gas)

Tank From Your Grili

1. Turn the Burner Knobs and LP gas tank valve

to the full OFF position. (Turn clockwise to
close.)

2. Detach the hose and regulator assembly from

the LP gas tank valve by turning the Quick
Coupling Nut counterclockwise. See Fig.7b

CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.

Connecting A Liquid Propane Gas (LP gas)

Tank To Your Grill

Figure 7a (LP gas model only)

Figure 7b (LP gas model only)

NUT

SIDE BURNER.

14

Advertising
This manual is related to the following products: