Awarning, Fire and explosion hazard – Kenmore I 53.329462 40 GALLON User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LIFT OUT TAB TO UNCLIP
TERMINAL COVER FROM
THERMOSTAT
8.
Tighten terminals 2 and 3 to ensure proper electrical
connection.
5.
FIGURE 16.
Remove the screws from terminal 2 of the element, and
move the looped end of the wire aside.
FIGURE 17.
The buss bar is labeled 5500 W. Place the buss bar over
terminals 2 and 3 with the 5500 W visible. Install the extra
screw provided into terminal 3.
AWARNING
Fire and Explosion Hazard
Failure to tighten screws can
cause afire.
Failure to do this could result in
death, serious bodily injury, or
property damage.
Failure to tighten terminal screws can cause a fire which can
result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE,
9.
Replace terminal cover on thermostat making sure that
the locking tabs on the terminal cover are in place.
AWARNING
Fire and Explosion Hazard
Thermostat
must
be
flush
against the tank.
Make sure terminal cover is in
place
and
the
insulation
replaced.
Failure to do this could result in
death, serious bodily injury, or
property damage.
Make sure the thermostat is flush against the tank, the terminal
cover is in place, and the insulation is replaced. Failure to do
so
can
result
in
DEATH,
SERIOUS
BODILY
INJURY,
OR
PROPERTY DAMAGE.
10.
Replace the insulation cap with handle so that it completely
covers the thermostat and element.
FIGURE 18.
7. The wire removed from terminal 2 has a looped end. It
must remain looped and now be placed (as shown) on
top of the buss bar, over the opening of terminal 2, and
secured using the remaining screw.
FIGURE 19.
13