Basic tools, Additional tools needed when sweat soldering, Materials needed – Kenmore I 53.329462 40 GALLON User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
EXPANSION
TANKS
FOR
THERMAL
EXPANSION CONDITIONS AVAILABLE IN 2
GALLONS , AND 5 GALLONS CAPACITY
THROUGH LOCAL SEARS STORE OR
SERVICE CENTER.
WATER HEATER INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR 3/4” OR 1/2”
THREADED OR COPPER PLUMBING
DRAIN PANS AVAILABLE IN 20”
DIAMETER
FOR WATER HEATERS
HAVING A DIAMETER 18” OR LESS,
24” DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 22"
OR LESS AND AVAILABLE IN 28”
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26” OR LESS.
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Folding
Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
SLOT-HEAD SCREWDRIVER
ROLL OF TEFLON TAPE (USE ON
WATER CONNECTIONS)
PHILLIPS SCREWDRIVER
l».PS bo^t
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER CONNECTIONS
GARDEN HOSE
6 FOOT TAPE
PIPE WRENCH
Additional Tools Needed When Sweat
Soldering
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder
Flux
Emery Cloth
Wire Brushes
TUBING CUTTER
Oc
HACKSAW
£L
ROLL OF
EMERY CLOTH
ROLL OF
LEAD-FREE
SOFT SOLDER
SOLDER
FLUX
3/4" (19 mm) WIRE BRUSH
PROPANE
TORCH
1/2” (13 mm) WIRE BRUSH