Troubleshooting, Dishwasher is not operating properly, Dishwasher does not run or stops during a cycle – Kenmore 665.15529 User Manual

Page 16: Dishwasher will not fill, Water remains in the dishwasher, Dishes are not completely clean, Food soil left on the dishes, Spots and stains on dishes, Spotting and filming on dishes

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

First try the solutions suggested here and possibiy avoid

the cost of a service cail...

Dishwasher is not operating properly

■ Dishwasher does not run or stops during a cycle

Is the door closed tightly and latched?

Is the right cycle selected? Refer to the “Cycle Selection

Charts.”

Is there power to the dishwasher? Has a household fuse

blown or circuit breaker tripped?

Has the motor stopped due to an overload? The motor

automatically resets itself within a few minutes. If it does not
restart, cal! for service.

Is the water shut-off valve (if installed) turned on?

■ Dishwasher will not fill

Is the overfiil protection float able to move up and down

freely? Press down to release.

■ Dishwasher seems to run too long

Is the water supplied to the dishwasher hot enough? The

dishwasher runs longer while heating water. Refer to the
“Dishwasher Efficiency Tips” section.

A delay automatically occurs in some wash and rinse cycles
until the water reaches the proper temperature.

■ Water remains in the dishwasher

Is the cycle complete?

■ Detergent remains in the covered section of the

dispenser

Is the cycie complete?

Is the detergent lump-free? Replace detergent if necessary.

Is the bottom rack installed properly with the bumpers in the

front? Refer to the “Parts and Features” section. Reinstat! the
rack if necessary.

■ White residue on the front of the access panel

Was too much detergent used? Refer to the “Detergent

Dispenser” section.

Is the brand of detergent making excess foam? Try a different

brand to reduce foaming and eliminate buildup.

Are dishes washed only every 2 or 3 days? Run a rinse cycie

once or twice a day until you have a full load.

Does the dishwasher have a new plastic smell? Run a vinegar
rinse as described in “Spotting and filming on dishes” tater in

this Troubleshooting guide.

Condensation on the kitchen counter (built-in models)

Is the dishwasher aligned with the countertop? Moisture from

the vent in the dishwasher console can form on the counter.

Refer to the Installation Instructions for more information.

Dishes are not completely clean

Food soil left on the dishes

Is the dishwasher loaded correctly? Refer to the “Dishwasher
Loading” section.

Is the water temperature too low? For best dishwashing
results, water should be 120'’F (49°C) as it enters the
dishwasher. Refer to the “Dishwasher Efficiency

Tips” section.

Did you use the correct amount of fresh detergent? Use
recommended dishwasher detergents oniy. Refer to the
“Detergent Dispenser” section. Never use less than 1 tb
(15 g) per load. Detergent must be fresh to be effective. Store
detergent in a coot, dry area. Heavy soil and/or hard water
generally require extra detergent.

Is detergent caked in dispenser? Use fresh detergent only. Do
not allow detergent to sit for several hours in a wet dispenser.
Clean dispenser when caked detergent is present.

Is the pump or spray arm clogged by labels from bottles and
cans? If you wash bottles and cans in your dishwasher, check

for labels clogging the pump or spray arm.

Is the home water pressure high enough for proper
dishwasher filling? Home water pressure should be
20 to 120 psi (138 to 828 kPa) for proper dishwasher fill. A
booster pump on the water supply can be added if pressure
is too tow.

Are high suds slowing the wash arm? Never use soap or

laundry detergents. Use recommended dishwasher
detergents only.

Spots and stains on dishes

■ Spotting and filming on dishes

Is your water hard or is there a high mineral content in your

water? Conditioning the final rinse water with a liquid rinse

aid helps eliminate spotting and filming. Keep the rinse aid
dispenser filled.

Is the water temperature too low? For best dishwashing
results, water should be 120'’F (49°C) as it enters the
dishwasher. Refer to the “Dishwasher Efficiency

Tips” section.

Did you use the correct amount of effective detergent? Use
recommended dishwasher detergents only. Refer to the
“Detergent Dispenser” section. Never use less than 1 tb (15 g)
per load. Detergent must be fresh to be effective. Store
detergent in a cool, dry area. Heavy soil and/or hard water
generally require extra detergent.

Odor in the dishwasher

16

Advertising
This manual is related to the following products: